Cestlavic® Sneaker Topcoat 60mL/2Fl Oz

This topcoat is super simple to apply and is self-leveling. After your Sneaker Tattoos and paint (if any) on your sneakers are completely dry, apply 3-5 thin layers of topcoat to seal in your design.

• To apply, decant about 1 tablespoon from the bottle. Only decant what you need, you can always pour out more topcoat when you run out.
• Use a wide, flat, synthetic paintbrush to apply the topcoat in a thin layer covering the entire panel.
• Change the direction of the brushstrokes by 45° angle for each layer to reduce streaking.
• Let the last layer fully dry to the touch before applying the next.
• Apply in total, 3-5 layers of topcoat for maximum protection.
• Let the topcoat cure for at least 24 hours before wearing. The topcoat can take up to 7 days to fully cure.

This topcoat is non-toxic and non-flammable but can stick to surfaces and be difficult to remove. Always work on a protected surface and avoid contact with eyes or mouth.

Cestlavic Sneaker Topcoat is professionally formulated for leather surfaces (genuine or faux leather), canvas, and rubber.

***Always be sure to spot-test on an inconspicuous area before starting your project.

This topcoat protects:

• sneaker-tattooed leather surfaces;
• newly colored/leather acrylic-painted leather surfaces;
• and/or newly restored leather surfaces.

This topcoat will seal in your Sneaker Tattoos® designs and make them:

• Scratch-proof
• Splash-proof
• UV and fade-resistant
• Longer-lasting

Cestlavic® Sneaker Topcoat goes a long long way! You can fully protect up to 10 pairs of sneakers with our 2Fl Oz bottle.

Amount needed may vary depending on the size of your canvas, for example, bags or furniture with greater surface area may require more topcoat for complete coverage.